201718th International Congress of Metrology
|Number of page(s)||5|
|Section||SI and new electrical standards / SI et nouvelles références en électricité|
|Published online||18 September 2017|
Bilateral comparison on transmission coefficient measurements between TÜBİTAK UME and SASO NMCC
1 National Metrology Institute (TUBITAK UME), Baris Mah Dr. Zeki Acar Cad. No.1 Gebze-Kocaeli, Turkey
2 National Measurement and Calibration Center (NMCC), Saudi Standards, Metrology and Quality Organization (SASO), Al Muhammadiyah-in front of King Saud University, PO. B 3437 11471 Riyadh, Kingdom of Saudi Arabia
* Corresponding author: firstname.lastname@example.org
This paper describes a bilateral comparison between two national metrology institutes, National Metrology Institute of Turkey (TÜBİTAK UME) and National Measurement and Calibration Center at Saudi Standards, Metrology and Quality Organization of the Kingdom of Saudi Arabia (SASO NMCC). The aim of the comparison is to check the newly installed SASO NMCC radio frequency and microwave laboratory infrastructure and assess compatibility between two institutes. Measured quantity of the comparison is transmission coefficient of fixed attenuators. The comparison was carried out in three months with 3 dB, 6 dB, 10 dB, 20 dB and 30 dB fixed attenuators. Measurements were performed using commercial Vector Network Analyzer in controlled environmental conditions. Two laboratories were used same measurement technique called as short, open, load and through. The analysis of the results provides good agreement between TÜBİTAK UME and SASO NMCC as a conclusion.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.