201718th International Congress of Metrology
|Number of page(s)||7|
|Section||SI and new electrical standards / SI et nouvelles références en électricité|
|Published online||18 September 2017|
Calibration factor comparison between TÜBİTAK UME and SASO NMCC
1 TÜBİTAK Ulusal Metroloji Enstitüsü, Dr. Zeki Acar Cad. No:1, Gebze-Kocaeli, Turkey
2 SASO National Measurement and Calibration Center, P.O. Box 3437, 11471, Riyadh, Kingdom of Saudi Arabia
* Corresponding author: firstname.lastname@example.org
Bilateral comparison of calibration factor of microwave power sensor was carried out between National Metrology Institute of Turkey (TÜBİTAK UME) and National Measurement and Calibration Center at Saudi Standards, Metrology and Quality Organization of the Kingdom of Saudi Arabia (SASO NMCC). In this comparison, TÜBİTAK UME was pilot laboratory and supplied the travelling standard with N type connector. Nine different frequency points at 0 dBm power level were determined for this comparison in prepared technical protocol. Each participant used their own measurement standards and applied the direct comparison transfer method at comparison. There is a good agreement between TÜBİTAK UME and SASO NMCC results.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.