201919th International Congress of Metrology
|Number of page(s)||4|
|Section||Mechanics Quantities / Grandeurs Mécaniques|
|Published online||23 September 2019|
Precision of the Residual Stress determined by X-ray Diffraction: Summery and Limits
Bochum University of Applied Sciences, Department of Mechatronics and Mechanical Engineering, D-44801 Bochum, Germany
Steinbeis-Transfercenter for Spring Technologies, Component Behaviour and Process, D-58638 Iserlohn, Germany
* Corresponding author: firstname.lastname@example.org
Today components specially for passenger cars are weight optimized. Often it is done by mechanical surface treatments. Therefore, the amount of compressive residual stress induced by the treatment must be known. The measurement is very often done by x-ray diffraction. But how precise can you determine (and not directly measured) the amount? A big question is the calibration of the equipment. A specimen must be designed and calibrated by round robin test, because no measurement standard is available.
© The Authors, published by EDP Sciences, 2019
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.