| Issue |
2013
16th International Congress of Metrology
|
|
|---|---|---|
| Article Number | 06014 | |
| Number of page(s) | 3 | |
| Section | Les avancées en mesure 3D et Dimensionnel / Advanced coordinate metrology & Dimensional | |
| DOI | https://doi.org/10.1051/metrology/201306014 | |
| Published online | 07 October 2013 | |
Traceable flatness calibration with substitution method
1 Tampere University of Technology, Department of Production Engineering, P.O.Box 589,, 33101, Tampere, Finland
a Corresponding author: tero.ristonen@tut.fi
This paper describes a traceable method to calibrate a flat surface with substitution method using aCMM within the manufacturing unit. Method has been tested in an accredited calibration laboratory with ahigh end CMM. Previous publications within academy have described flatness measurement end theuncertainty connected with it very thoroughly, but now the trace to definition of the meter is introduced.
© Owned by the authors, published by EDP Sciences, 2013
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 2.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.