| Numéro |
2017
18th International Congress of Metrology
|
|
|---|---|---|
| Numéro d'article | 15004 | |
| Nombre de pages | 4 | |
| Section | Optical agile measurement / Flexibilité des mesures optiques | |
| DOI | https://doi.org/10.1051/metrology/201715004 | |
| Publié en ligne | 18 septembre 2017 | |
Performance of a low cost laser scanner using a granite square gauge
Performance d’un scanner laser à faible coût à l’aide d’une jauge carrée de granite
1 Universidade de Brasília, UnB, Faculdade de Tecnologia, Depto. Engenharia Mecânica, Brasília, DF, Brazil
2 LURPA, École Normale Superieure - ENS Cachan, 61, av. du Président Wilson, Cachan, France
3 Universidade Federal de Uberlândia – UFU, Faculdade de Engenharia Mecânica, Uberlândia, MG, Brazil
This work deals with performance verification of a low cost laser scanner with a granite square gauge. This gauge has well finished surfaces and dimensional precision, enough for verification of a low cost laser scanner. The square was initially measured with the scanner and a cloud of points was saved in a file. A filtering method was applied to extract noise from data and the flatness deviation of each plane, together with the angle between planes, were determined. MatLab software was used as a tool to determine the deviations and angles. Analysis of normality of data was carried out with normal probability plot graphs. Results were compared and were below from scanner manufacturer ones. It was observed that deviations were above stated in manufacturer manual.
Key words: laser scanner / performance / square gauge
Mots clés : laser scanner / performance / étalon carré
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.